We are closed Tue, Nov 25 until Sun, Nov 30. Any orders placed online will ship after we re-open on Mon, Dec 1. Your patience is appreciated. Happy Holidays! Home >  IDE to SATA Adapter - Converts IDE Drive to SATA Interf Product is Out of Stock and/or Discontinued. Product No: 13735 Comments There are currently 0 comments to display. Your Name: Email Address (will not appear on web site): Image verification: Message: New, Retail Blister Pack. 30 Days Warranty. Weight: 0.13 lbs., Dimensions: 2x1x1 inches Connect an IDE hard drive to your motherboard's Serial ATA controller with this IDE to SATA Converter! It features the JMicron JM20330 chipset and supports 3.5-inch IDE hard drives and 5.25-inch optical drives. It's compliant with Serial ATA specification and supports up to UDMA/133 drives! WARNING:The solder used in this product contains lead, a chemical known to the State of California to cause birth defects and other reproductive harm. Please wash hands after handling internal components and circuit boards and avoid inhalation of fumes if heating the solder. Features/Specifications: IDE to SATA Converter Adapter General Features: JMicron JM20330 chipset Compliant with Serial ATA specification Supports 3.5-inch and 5.25-inch IDE hard and optical drives ATA/ATAPI Ultra DMA of transfer rate 16.7, 25, 33, 48, 66, 100, 133 and 150 Mbps Support ATA PIO and UDMA modes 0 to 4 Ultra low power consumption Plug & Play and Hot-swapping capability Support Windows 98SE/ME/2000/XP Operating System Connectors: One (1) 40-pin IDE connector One (1) Serial ATA (SATA) port One (1) 4-pin power connector Package Includes: IDE to SATA Converter Adapter SATA cable 4-pin large and small power connector Additional Information: Product Requirements: Available 4-pin power supply connector Computer with SATA host interface Supported drive Previous: NVIDIA GeForce 8500GT Super 512MB DDR2 PCI-E VCD w/DVI Next: IBM 20.5GB UDMA/100 7200RPM 2MB IDE Hard Drive